Feel Safer in Your Bathroom by Installing Grab Bars to Your Shower Wall

The shower could be a very frightening place when all individuals cleaning soap suds begin to accumulate on the ground of the shower. One method to feel safer within the shower would be to use a grab bar towards the wall. Listed here are the various tools you'll need and directions to correctly use a grab bar inside your tiled bathroom shower.

After you have acquired a grab bar you have to collect the various tools required to do the installation. Listed here are the various tools you'll need:



Philips-mind screwdriver

Drill

1/8 inch masonry bit or glass and tile bit

Stud finder or perhaps a period of wire

Tape-measure

Silicone caulk

Sharp awl or carbide glass and tile drill bit

Wood bit, 1/16 narrower than how big mounting screws

The very first factor that you'll want to complete to set up your grab bar is to locate wall stud.  If you can get a stud finder this helps greatly.  Run the stud finder across the wall until a wall stud is situated and mark the place having a fine point marker.  If you don't come with an electronic stud finder, don’t worry, simply take singleOr8 masonry bit or glass and tile bit and just drill an opening in to the grout.  Then bring your period of wire making a bend inside it.  Place the wire within the hole by spinning it right and left you need to hit a stud.  If you don't choose a stud, the opening that you simply drilled can contain a small little bit of silicone caulk.  Make certain to flatten the dab of silicone caulk so it doesn't protrude in the grout line, permit the caulk to dry for around three hrs.  For those who have powdered grout handy, combine a little and patch the opening.  Re-drill another hole before you choose a stud.  Whenever you do look for a stud, measure 16 inches from that hole and you ought to have the ability to drill into another stud.

You will need to mark your stud locations to ensure that you are able to measure from the bottom of the bathtub to look for the positioning of the bar.  Put your bar to ensure that each finish has ended a stud and mark the screw holes which are within the mounting bracket.

To drill the mounting holes into tile you will have to create a beginning point for that drill bit otherwise the part will stumble upon the tile.  To create a beginning point make use of a sharp awl or afore pointed out drill bit.  Making use of your hands, twist the instrument in your make to create a slight impression around the tile this can keep the drill bit from sliding.  Don't use a punch or you'll probably crack your tile.  Make use of the glass and tile bit to drill your hole.  If utilizing a masonry bit, place tape within the tile and drill gradually to prevent breaking the tile.  You shouldn't break your tiles when messing the supports on either so use a little that's 1/32 wider than how big the mounting screw you'll be using.  Start drilling the opening gradually with even pressure so they won't slide off your mark.  Use light pressure when drilling to prevent cracking the tile.

Make certain to not drill much deeper compared to tile also it backing. At this time, you will have to improve your bit towards the wood bit 1/16 narrower compared to screw.  This makes an airplane pilot hole within the studs.

The ultimate step would be to mount the bar.  Silicone caulk will have to be put on the holes before mounting this really is to safeguard the wood and backing boards behind the tiles from seeping water.  Simply screw the bar towards the wall.  You will need to use stainless screw or they'll rust.  Tighten the screws firmly ensuring not to over tighten them or they'll crack the tile.

You need to are in possession of your grab bar correctly installed.  Now you can have a peaceful, relaxing shower and feel safer along the way.